Plug and Play 4S 100A 12v - 14.6v LiFePO4 BMS LED Battery Balance No Soldering

Description

Note: This BMS is a custom model that comes pre assembled for easy install (no soldering needed) and is for
LiFePO4, LiFe, or LFP
batteries.
Lithium-ion (Li-ion)/
Lithium-polymer (LiPo)
based BMS boards are in my other listings.
Description:
This BMS balance board is used for a lithium battery pack to equalize voltage and protect the cells. This module charges, discharges, balances, and acts as a low voltage/over charge cutoff.  We have pre installed a screw based connection block for the easy connection of balance wires to the BMS.
The BMS is assembled to use a COMMON Port setup for both charge and discharge at 80A (continuous) and discharge at 100A (burst).
The following is the BMS parts list:
(1) BMS Board
LiFePO4 LiFe LFP
(2) Ring Terminal Connectors M3,
8-16AWG Wire
Compatibility
(2) Ring Terminal Screws and Washers
(1) Pre-installed balance wire connection block, 16-24AWG Wire Compatibility
*Wires are not included. Balance wires of 16-24AWG will fit in the balance connection terminal and primary wires of
8-16AWG can be used in the ring connectors. Larger gauge primary wires can be used with larger ring connectors or solder points.
Battery compatibility: Voltage of 2.4V - 3.7V LiFePO4 battery types
Charging input voltage: 12V - 14.6V
Maximum starting current: 100A
Maximum
continuous current: 80A
Charge current: 60A
Maximum
continuous
current (additional solder point): 100A
Board Size: approx. 42*60*7.4mm
Package includes: 1 x LiFePO4 Battery Protection Board
Condition is New. Shipped with USPS First Class.