3D Printed "Goblin Drone" FPV Drone Frame by ProgrammaDan

Description

Print is made out of PETG + Carbon Fiber
Will not come with any electronics
Color will come in black:
Build recommendation:
AIO flight controller ESC ( 25.5 mm x 25.5 mm mount)
VTX - HGLRC Zeus Nano:
Camera - RunCam Nano 2 w/  2.1mm lens:
ELRS receiver - (Ok literally any micro ERLS receiver will do, but I used the HAPPYMODEL EXPRESSLRS 2.4GHZ EP2 w/ ceramic antenna)
Motors - flashhobby A1106 1106 6500kv Brushless Motor
Battery -
Only 2s OR 3s
(At 3S the ESC can handle 3020 props at most, and the motors can't handle 4s at all) battery between 500 and 1000mah. At the moment my favorite battery to use for this drone is this one:
Mechanical Parts:
6x M2x4 insert nuts
4x 3020 propeller (or any another 3 inch propeller, or even 2.5 inch for that matter)
10mm x 180mm velcro strap:
6x M2x6 screw (for securing top to body)
18x M2x5 screw (16 for attaching the motors, 2 for securing VTX)
4x M2x14
low profile*
screw
and
4x M2 nut (for attaching flight controller esc stack)
Additional* - You will need 2x M2x4 screws for attaching the camera and 8x M2x7 screws for attaching the propellers, but at least in my case, those screws were included with the camera and motors.